Geoffro

Level 1 Access

Added 2018-01-31 15:36:53 +0000 UTC

Hi all,

Well, Vader is completed, just doing assembly images and all the clean up work, test slicing etc. So all on track for that I would say tomorrow,

Some of you may have seen the pic I posted on the facebook page for the technicolor elephant. It is a very easy print but just a long one, and something you can do over time if you want to use up those scraps of filament.

This is for all Patrons, it is part of the next print week but considering my upload woes this week I thought I'd at least try and get something up asap.

There are 90 parts + the tusks.

Print 1&2, 3&4, 5&6 and continue on like that. You could print it in only 2 colors for a checker pattern, you just alternate the numbers. Ie all black for 1,3,5,7 etc and Red for 2,4,6,8 etc.

Each piece is an opposing piece of the other. but there is no doubles, this is the original set of files I used to print it - so when you load them you might need to rotate them to the flat side, but they are all cut on 90' angles so there isn't any messing around needed.

https://www.dropbox.com/s/94x8czlhnibdijt/HEX3DMULTI-ELEPHANT.zip?dl=0

More coming tomorrow!