Han in Carbonite Micro Diorama
Added 2021-07-25 14:01:04 +0000 UTCI wanted to make sure that those with smaller printers didn't miss out on any printing this week!
This micro diorama prints on the Ender 3 Pro (210mm tall) and has been split up for very easy printing and painting.
I recommend using a 3M command strip to attach Han to the wall.
You can optionally set the back and floor pieces to something like 150% width in your slicer and make slightly wider diorama (print multiples of the top detail). You can also extend the depth as well, just keep it your %'s consistent through the back and floor pieces. Print the other pieces normally.
Comments
Any suggestions for printing the grate. Having some issues. Everything else printed ok.
Jay Roney
2024-01-26 15:36:52 +0000 UTCHaving an issue with the grate as well. Any recommendations?
Jay Roney
2024-01-26 14:35:06 +0000 UTCI am having a issue with the grate has anyone else really wanted this but no dice
Nathan Berg
2023-03-18 08:52:05 +0000 UTC
![MIJIN [Felicia]](https://samukata.com/istorage/79670.jpg)
